Which products are suitable for the fine water die frame

Fine water die stand (also known as double/multi-parting surface die stand), standard length and width specifications from 200mmx250mm (referred to as 2025 series) to 500mmx700mm (referred to as 5070 series); There are four more pull rods controlling the opening and closing stroke of the template and one water plate than the large water plate, and it is divided into two categories: D and E type, D type has A water plate and E type does not, and the same as the large water plate, it is divided into A, B, C, D four models due to the different configuration of the plate, but the fine water plate only has two categories: I-type and straight die (H-type). A total of 16 different models and specifications, mold makers can configure different plate thickness combinations according to product requirements.

Fine water mouth mold (also known as three plate mold) : the runner and the gate are not the same parting mold line; The product is demoulded online in the parting mold, and the water mouth material is demoulded online in the parting mold of the water mouth plate. Because the fine nozzle needs to design more than one set of nozzle plate parting line and control mold opening and closing stroke device, the design is complicated, and the production time and cost will be larger and higher. Since the product and gate have been separated, the appearance is better, and there is no need to increase the subsequent water separation work.

The industrial mold is divided into large nozzle, simplified/fine nozzle, fine nozzle, simplified nozzle, and a variety of flower styles. Many people are not clear about the application of the mold frame of the fine water mouth, let's analyze it.

Fine water die frame is mainly applicable to the following products:

1, the shape of the object mold is more complex, and the edge of the mold is difficult to enter rubber products. This is the time to use the fine water mold holder.

2, some gate location can not be located on the edge of the product, can not be directly in the middle of the glue product.

3, some are particularly large, a glue point can not meet the requirements of injection molding products. It's time to change the nozzle.

It can be seen that special molds and complex molds are more suitable for the use of fine water mouth molds!